HP MPX200 Multifunction Router - Manual (Page 250)

2. Enter the following command to set the FTP transfer type to binary:
ftp> bin
3. Enter the following command to put the HP_StorageWorks_MPX200_FRU.bin file:
ftp> put HP_StorageWorks_MPX200_FRU.bin
4. Log in to the MPX200 using a Telnet session to the management port or console port:
Username: guest
Password: password
5. Enter the following command:
MPX200> admin start
6. Enter config as the password.
7. Enter the following command:
MPX200 (admin) #> fru restore
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the Enter key to accept the current
value. If you wish to terminate this process before reaching the end
of the list press 'q' or 'Q' and the Enter key to do so. Type of restore
(0=full, 1=mappings only) [full]
FRU restore completed.
8. Reboot the system for the configuration to take effect.
250 Saving and restoring the MPX200 configuration