HP MPX200 Multifunction Router - Manual (Page 237)

Table 36 WD log messages (continued)
Wanlink Test failed because error
occurred while reading port
information. Error User WD: wanlinktest setup GetportInfo Failed.
Path MTU calculation process not
started due to insufficient resources. Error User WD: Unable to start PMTU thread due to
insufficient system resources
Wanlink Test not started on server side. Error User WD: wanlinktest setup on {GE2 ip
1.1.1.1 socket xxxx} failed.
Wanlink Test failed because error
occurred while reading port
information. Error User WD: wanlinktest start GetportInfo Failed.
xx
Wanlink Test Calcluation cannot
proceed due to low memory. Error User WD: Unable to perform The Client
Calculation due insufficient system
resources
Error occurred while stopping Wanlink
Test. Error User WD: Unable to stop Wan Link Test
Calculation, rc = xx
Error occurred while stopping PMTU
discovery process. Error User WD: Unable to stop PMTU Server, rc =
xx
Ping test failed. Error User WD: error getting RTT Ping returned -1
s:1.1.1.1 d:1.1.1.2
Ping test failed. Error User WD: 1.1.1.2 Not reachable:42485
Wanlink Testing failed. Error User WD: wanlinktest src 1.1.1.1 dest
1.1.1.2:3260 failed
237