HP MPX200 Multifunction Router - Manual (Page 144)

Locating the MPX200 blade
A flashing blue LED indicates that the MPX200 blade beacon is ON. There are two ways to identify
the location of an MPX200 blade:
•
Enter the CLI command beacon on ( Figure 124 (page 144) ).
Figure 124 Using the beacon on command to locate an MPX200 blade
•
In HP P6000 Command View, select the General tab, and then click the Locate button. Use
the Locate ON and Locate OFF buttons to control the blue LED (
Figure 125 (page 144) ).
Figure 125 Using HP P6000 Command View to locate a hardware device
MPX200 log data
The MPX200 maintains a log that can be displayed through the CLI. The log is persistent through
reboots or power cycles. To view the log, use the CLI command show logs.
For log data descriptions, see “MPX200 log messages” (page 216) , “DM log messages” (page 232) .
MPX200 statistics
Statistics for the iSCSI and Fibre Channel ports are available through the CLI. To view statistics,
use the CLI command show stats.
MPX200 ping command
The ping command is the most basic network troubleshooting tool that is available to troubleshoot
FCIP route problems. This command runs a diagnostic in which a message is sent to a destination,
144 Diagnostics and troubleshooting