HP MPX200 Multifunction Router - Manual (Page 100)

6. Enter the CHAP secret for the MPX200-discovered iSCSI initiator in the Target Secret box.
7. Click OK.
8. Click OK again.
The initiator completes normal login.
Enabling CHAP for the MPX200-discovered iSCSI initiator entry
You must use the CLI to enable CHAP for the MPX200-discovered iSCSI initiator entry:
•
If the iSCSI initiator is not listed when you execute the set chap command, do one of the
following:
◦ From HP P6000 Command View, select Hosts, and then select the Add Host tab. Enter
the IQN string.
◦ From the CLI, use the add command to add the iSCSI initiator that performs the discovery.
•
If the iSCSI initiator is listed when you execute the set chap command, then enable the
CHAP secret (for example, CHAPsecret01):
1.
Select the index of the iSCSI initiator.
2. Enable CHAP by selecting 0 and then entering the CHAP secret.
Enabling CHAP for the Microsoft iSCSI initiator
To enable CHAP for the Microsoft iSCSI initiator:
1.
Click Discovery. To manually discover iSCSI target portals:
a.
Click Add under Target Portals.
b. Enter the IP address of the iSCSI port of the MPX200.
c. Click Advanced.
d. Select the CHAP Login Information check box.
e. Enter the CHAP secret for the MPX200-discovered iSCSI initiator in the Target Secret box
(for example, CHAPsecret01).
f. Click OK and the initiator completes Target discovery. Using iSNS for target discovery:
•
Click Add under iSNS Servers.
•
Enter the IP address of the iSNS server.
•
Click OK.
2. Click Targets and select the appropriate target for login.
3. Click Log On and then click Advanced.
4. Select the CHAP Login Information check box.
5. Enter the CHAP secret for the MPX200-discovered iSCSI initiator in the Target Secret box.
6. Click OK.
7. Click OK again.
100 MPX200 iSCSI configuration rules and guidelines