HP MPX200 Multifunction Router - Manual (Page 43)

1. Run the show vpgroups command and observe the fourth bit in the output to identify the
WWNs belonging to a VPG. See
Figure 36 (page 43) .
Figure 36 The show vpgroups command
2. Using the InForm Management Console, create a host and add only WWNs that belong to
the same VPG.
There can be up to four hosts that represent the MPX200.
NOTE: Figure 37 (page 43) shows an example with eight connections from the MPX200 to
the array. Each of the four FC ports detects two array ports.
Figure 37 Host properties
LUN provisioning 43