HP MPX200 Multifunction Router - Manual (Page 217)

Table 34 MPX200 log messages (continued)
Unable to create an object for the
target node; exceeded the maximum
number of target devices. Error App QLBA_CreateTargetNodeObject:
Too many devices
41060
Memory unavailable for LUN object. Error App QLBA_CreateLunObject: LunObject
memory unavailable
41067
Unable to create an object for initiator
object; exceeded the maximum
number of initiators. Error App QLBA_CreateInitiatorObject: Too
many initiators
41077
Process control block status indicates
that a PCI error occurred during a
target operation. Error App QLBA_DisplayTargetOperationStatus:
PCI Error, Status 0x%.2x
41096
Process control block status indicates
that a DMA error occurred during an
initiator operation. Error App QLBA_DisplayInitiatorOperationStatus:
DMA Error, Status 0x%.2x
41106
Process control block status indicates
that a transport error (protocol)
occurred during an initiator operation. Error App QLBA_DisplayInitiatorOperationStatus:
Transport Error, Status 0x%.2x
41107
Process control block status indicates
that a data overrun error occurred
during an initiator operation. Error App QLBA_DisplayInitiatorOperationStatus:
Data Overrun, Status 0x%.2x
41111
iSCSI login failed between receipt of
PDU and request for the data segment. Error App QLIS_LoginPduContinue:
Operation failed. Initiator
0x%x, TPB status 0x%x
41234
iSCSI login failed due to unsupported
version number in received login PDU. Error App QLKV_ValidateLoginTransitCsgNsgVersion
failed (status 0x%x)
41238
iSCSI login PDU contains invalid
initiator name. The format and Error App QLIS_LoginPduContinue: Invalid
initiator name. Initiator:
41257
character set used to form the initiator
name is invalid.
iSCSI target login was attempted to a
portal (iSCSI1 or iSCSI2) on which the
target is not presented. Error App QLIS_LoginPduContinue: Target
not configured for Portal
41265
iSCSI login PDU received for a target
with a target name unknown to the
router. Error App QLIS_LoginPduContinue: Target
not found. Target name:
41267
iSCSI login PDU received without a
target name for a normal session. Error App QLIS_LoginPduContinue: Missing
target name
41268
iSCSI login PDU received without an
initiator name key/value. Error App QLIS_LoginPduContinue: TSIH is
0 but InitiatorName key/value
not provided
41270
iSCSI login PDU received with an
incorrect initiator task tag for a session Error App QLIS_LoginPduContinue:
CONN_STATE_IN_LOGIN, Unknown
InitTaskTag
41272
which is partially logged in. This
would occur if a login PDU other than
the initial login PDU used an initiator
task tag which was different than the
initiator task tag provided in the initial
login PDU.
iSCSI login PDU was received with a
TSIH out of range. This would occur if Error App QLIS_LoginPduContinue: TSIH
0x%x out of range
41283
the iSCSI initiator attempting the login
failed to used the TSIH value provided
in the Target Login Response PDU
217