HP MPX200 Multifunction Router - Manual (Page 129)

8. Enter the command set mgmt to set the initial parameters.
Follow the on-screen prompts to configure the management port (or press Enter to accept the
default settings, as shown in
Figure 108 (page 129) ):
Figure 108 Setting IP addresses
The management port is now configured with the appropriate IP address and network
parameters.
IMPORTANT: If you are using Telnet to configure the MPX200, the Telnet session is terminated.
To restart the Telnet session, use the IP address you just assigned to the management port.
Step 6. Configure the MPX200 FCIP Route parameters
Install FCIP license
For each MPX200 chassis, select the blade with the serial number used to obtain either the Full or
Half Chassis License and add the FCIP license as shown in
Figure 109 (page 129) . A Full Chassis
License enables both slots, while a Half Chassis License only enables one slot.
Figure 109 FCIP License Add
Configuring an FCIP route 129