HP MPX200 Multifunction Router - Manual (Page 134)

Figure 111 FCoE end-to-end fabric-connect storage configuration
26653d
Servers with CNAs Servers with NICs
FCoE/IP
/iSCSI
MPX200
FCoE/iSCSI
target
FCoE/iSCSI
Fibre
Channel
Storage systems
Ethernet
network
Fabric B
Fabric A
Converged
network
iSCSI/IP
IP
GE1 GE2 IOIOI FC1 FC2 MGMT
10GbE4 10GbE3 HP StorageWorks MPX200 10 - 1 GbE Blade MPX200 Multifunction Router
GE1 GE2 IOIOI FC1 FC2 MGMT
10GbE4 10GbE3 HP StorageWorks MPX200 10 - 1 GbE Blade MPX200 Multifunction Router
10-GbE/FCoE A/FCoE B connection
iSCSI/IP connection
10-GbE connection
10-GbE FCoE/iSCSI connection
Fabric A Fibre Channel connection
Fabric B Fibre Channel connection
X-series CN switches
Setting up for FCoE connectivity to HP P6000 EVAs
Before executing the following procedure, ensure that MPX200 discovery has been completed as
described in
“Managing MPX200 iSCSI using HP P6000 Command View” (page 31) .
To set up for FCoE:
1.
Configure the FCoE enabled converged network switch. Depending on the switch vendor,
configure the ports for FCoE use.
For information regarding switch setup, see the Fibre Channel Over Ethernet chapter of the
HP SAN Design Reference Guide, available at:
http://www.hp.com/go/sdgmanuals
The MPX200 10-GbE ports must be connected to the FCoE switch, as described in the section
“FCoE configurations” (page 133) .
2. Set up the CNA. For more information regarding CNA configuration, see the HP Emulex
Converged Network Adapter Installation Guide at:
http://bizsupport1.austin.hp.com/bc/docs/support/SupportManual/c02018539/
c02018539.pdf
a. Install the driver for the CNA.
b. Depending on the CNA vendor, use the management tool to determine the
WWNN/WWPN for each port on the CNA.
134 MPX200 FCoE feature description