HP MPX200 Multifunction Router - Manual (Page 67)

1. Select the Multipath I/O check box on the Select Features page ( Figure 59 (page 67) ).
Figure 59 Select Features page
2. Click Next, and then click Install.
3. After the server reboots, add support for iSCSI devices using the MPIO applet ( Figure 60 (page
67) and Figure 61 (page 68) ).
NOTE: You must present a virtual disk to the initiator to enable the Add support for iSCSI
devices check box (see Figure 60 (page 67) ).
Figure 60 MPIO Properties page before reboot
Setting up the iSCSI initiator 67