HP MPX200 Multifunction Router - Manual (Page 37)

Figure 25 Code Load page for the iSCSI controller
Shutting down and restarting the MPX200
If you need to restart the MPX200, select the General tab, and then click Restart. If you need to
shut down the MPX200, click Shut down. See
Figure 26 (page 37) .
Figure 26 iSCSI controller shutdown options
Saving or restoring the MPX200 configuration
After initial setup of the MPX200, it is a good practice to save the configuration. The FRU Save
function allows you to save the configuration to a file that can be used later as a restoration point.
The FRU Restore function allows you to restore the configuration to the point when the configuration
was last saved, which is especially important for single-blade configurations.
NOTE: A Restore action reboots the blade.
In a dual-blade configuration, a copy of the configuration for each router is kept on the peer. If
you add a new blade, the configuration of the peer blade is copied to the new blade and is ready
for use immediately; no reconfiguration is required.
To save or restore the MPX200 configuration:
1.
Select the desired blade.
Shutting down and restarting the MPX200 37