HP MPX200 Multifunction Router - Manual (Page 40)

5 Managing MPX200 iSCSI for 3PAR StoreServ Storage
This chapter describes management procedures for configuring and managing MPX200 iSCSI
with 3PAR StoreServ 10000/7000, 3PAR T-Class/F-Class Storage. For more information, see
“MPX200 iSCSI configuration rules and guidelines” (page 52) .
Setting up the MPX200 management port
Access to the MPX200 CLI is required for initial setup. Connect to the CLI through one of the
following:
•
RS-232 serial port (115200/8/n/1)
•
Telnet
•
SSH
When connected, select the blade to manage by using the blade <1 | 2> command.
By default, the management port obtains a DHCP address. If the management port cannot obtain
a DHCP address, you must set a static IP address. HP highly recommends using static IP addresses
to retain connectivity. See
Figure 31 (page 40) .
Figure 31 The blade # command
Enter the admin start command to change settings. See Figure 32 (page 40) .
Figure 32 The admin start command
Enter the set mgmt command to setup the management port IP address. See Figure 33 (page
41) .
40 Managing MPX200 iSCSI for 3PAR StoreServ Storage