HP MPX200 Multifunction Router - Manual (Page 225)

Table 34 MPX200 log messages (continued)
or has run out of resources to execute
additional commands.
FC processor was disabled by an
IOCTL request to the driver. Error FC #%d: QLIoctlEnable: Adapter
disabled
106589
FC processor firmware failed
initialization. The request to initialize Error FC #%d: QLIoctlEnable: Initialize
FW error
106590
was received by the driver in an
IOCTL request.
FC processor failed the external
loopback test. Error FC #%d: QLIoctlRunDiag: Diagnostic
loopback command failed %x % %x
%x
106592
FC processor failed to re-initialize in
response to an IOCTL disable request. Error FC #%d: QLIoctlDisable:
Re-initialize adapter failed
106593
FC processor reported a link down
condition. Error FC #%d: QLIsrEventHandler: Link
down (%x)
106803
FC processor reported an unexpected
asynchronous event. The mailbox Error FC #%d: QLIsrEventHandler:
Unexpected async event (%x),
106813
registers provide status, event code,
and data related to the event. MB1=%x, MB2=%x, MB3=%x, MB4=%x,
MB5=%x, MB6=%x, MB7=%x
FC controller reported an invalid Entry
Status %x, type %x. Error FC #%d: QLProcessResponseQueue:
Invalid EntryStatus %x, type %x
106847
FC controller failed to provide a
heartbeat. Error FC #%d: QLTimer: Heartbeat failed 106851
Driver has determined that the FC link
is unreliable and unusable due to the Error FC #%d: QLTimer: Link error count
(0x%x) exceeded, link down
106853
number of errors encountered. The link
has been taken down.
FC processor was unable to obtain the
number of loop IDs required. This Error FC #%d: QLReserveLoopId: out of
loop Ids
106912
failure occurs only when the FC
processor is running multi-ID firmware.
Driver was unable to re-establish
connection to the target within the Error FC #%d: QLMarkDeviceOffline:
Device Id: %x marked offline,
106928
timeout and retry counts, and is
therefore marking it offline. cLinkDownTimeout = %x,
cPortDownRetryCount=%x
FC processor is unable to log into the
FC fabric name server. Error FC #%d: QLSnsGetAllNext: Name
server login FAILED %x
106948
Driver host (initiator) database is full. Error FC #%d: QLUpdateDeviceData: out of
slots in host database
107029
Driver target database is full. Error FC #%d: QLUpdateDeviceData: out of
slots in target database
107030
Driver host (initiator) database is full.
Maximum hosts is 64. Error FC #%d: QLUpdateDeviceDatabase
0x%x: GET_ID failed %x
107041
Drivers host (initiator) database is full. Error FC #%d: QLUpdateDeviceDatabase 0x%x: out
of slots in host database 107056
Driver was unable to re-establish
connection to the target within the Error FC #%d: QLUpdatePort 0x%x: out of
slots in host database
107078
timeout and retry counts, and is
therefore marking it offline.
FC controller failed a Flash write
(address x data x). Error FC #%d: QLWriteFlashDword: Write
fails at addr 0x%x data 0x%x
107984
225