HP MPX200 Multifunction Router - Manual (Page 30)

6. Install the HP MPX200 bezel:
a.
Remove the four 10-32 x 3/8 in. screws that secure the rack rails to the front of the rack.
b. Position the bezel support plate in front of the MPX200 chassis, with the arrows pointing
up.
c. Replace the four 10-32 x 3/8 in. screws, two on each side of the bezel support plate.
d. Install the bezel by pushing it through the white pop-in tabs on the bezel support plate
(
Figure 17 (page 30) ).
Figure 17 Bezel view
2. Bezel mount bracket 1. Screw, panhead, 10-32 x 3/8 in.
4. Bezel 3. Bracket arrows
30 Installing the MPX200