HP MPX200 Multifunction Router - Manual (Page 38)

2. Click Set Options.
3. Click Save Configuration.
4. Select a configuration method, and then click Select (see Figure 27 (page 38) ).
Figure 27 iSCSI controller configuration selection
Locating the MPX200
A flashing blue LED in the center of the blade indicates that the locating beacon is on.
NOTE: The beacon turns off after 15 minutes.
Figure 28 Blue LED locating beacon
2. System power LED 1. Input fault LED
4. 1-GbE or 10-GbE iSCSI ports 3. Heartbeat LED
6. Maintenance button 5. 1–GbE iSCSI ports
8. UID beacon (blue LED) 7. 8–Gb/s FC ports
10. Management port 10/100/1000 Ethernet 9. RS-232 port
To enable or disable the locating beacon:
1.
Select the iSCSI controller.
2. Click Locate.
3. Click Locate ON or Locate OFF, and then click OK ( Figure 29 (page 39) ).
38 Managing MPX200 iSCSI using HP P6000 Command View