HP MPX200 Multifunction Router - Manual (Page 232)

Table 34 MPX200 log messages (continued)
The FCIP route #n went down because
the Fibre Channel port on the remote
peer went down. Error FCIP FcipRoute#%d: FC link on the
remote peer went down
172322
TCP link for FCIP route #n has been
established. Info FCIP FcipRoute#%d: TCP Link Up 184515
FCIP link is up for FCIP route #n. Info FCIP FcipRoute#%d: FCIP Link Up 184536
FCIP route #n: Incorrect VLAN
configuration. Error FCIP FcipRoute#%d: VLAN Info
Unavailable
184542
Ethernet port was not able to negotiate
the configured speed. Error NIC QL3xxx:%s: Auto Negotiation
error detected
205571
Ethernet port speed is not supported. Error NIC QL3xxx:eth%d: Unsupported speed
portConfig 0x%x
205572
Ethernet device could not be
configured. Error NIC QL3xxx:ql3xxx_probe: cannot
allocate ethernet device %s
206080
The Ethernet port was not able to
register as a network device, resulting Error NIC QL3xxx:ql3xxx_probe: cannot
register network device %s
206089
in a port initialization error for the
specified network device.
The total number of TCP checksum
errors detected on the Ethernet link
belonging to the eth#%d port. Error NIC QL3xxx:eth%d: TCP/IP checksum
error - TotalChecksumErrorCount
= %lu
206114
Ethernet port is operating at 100Mbps
speed. Info NIC QL3xxx:%s: PHY Downshift
occurred
217856
Ethernet link is up. Info NIC QL3xxx:%s: Link Up 217857
Ethernet link is down. Info NIC QL3xxx:%s: Link Down 217858
Ethernet port is down. Info NIC QL3xxx:%s Adapter Down 218389
Ethernet port is up. Info NIC QL3xxx:%s Adapter Up 218401
Uncorrectable memory error detected
at address provided in log message. Fatal System "memory monitor: Detected
Uncorrectable Ecc %08lx system
is rebooting in 5 secs\n"
233473
Attempt to register the interrupt
handler failed. Fatal System "Failed to register interrupt
handler!\n"
233474
Failed class_simple_create
system call from memory monitor
initialization routine. Fatal System "%s class_simple_create
failed\n"
233475
Failed to kill system task. Error System "Failed to kill sys killer
%d\n"
237572
Router temperature has exceeded the
high temperature threshold. Error System Temperature over high threshold
%d
237573
Router temperature has returned to the
normal operating range. Info System Temperature is back to normal
range %d
249862
Table 35 DM log messages
Description Msg type Module type Log Message ID
An error occurred on an I/O that
was issued for a migration job. Error App QLDM_HandleMigError: Migration
Job %d stopped for Src Lun %hd
44549
The description provides the job Dest Lun %hd Error %x
232 Log messages