HP Access Control - Manual (Page 64)

Figure 6-15 Snmp options
The default setting is “public” for Set and Get. If values are changed on the devices, all devices must have the
same value for Set and Get, or no value (public).
The default Trap level is Printer Confirmation traps. In the default mode, only printed job traps are sent. This
is used to reduce the network traffic with unwanted traps. Some versions of HP JetDirect require that “All
traps” mode is selected.
The trap service is using the default 162 UDP port. If the port is used by another application or service on the
same server, HP Access Control (HP AC) Job Accounting Trap service can use another port. If the port is
changed, the HP Access Control (HP AC) Job Accounting Trap service (HPACJA_SnmpTrap) needs to be
stopped and restarted and the printer reconfigured using the new port.
The Filter Delay is used if JetDirect sends the same trap multiple times in a very short interval. This occurs on
external JetDirect 300x and 500x. The delay value can be set to 50 ms for 300x and 500x. For others devices,
the default value can remain at 0.
50 Chapter 6 Configuring data collectors