HP Access Control - Manual (Page 59)

Figure 6-7 Device folder
FTP mode pushes files in ..\HP AC\Temporary\x.x.x.x folder, where x.x.x.x is the printer IP address.
HTTP and HTTPS modes push files in ..\HP AC\Temporary\DTM folder. The file name starts with the printer IP
address.
TIP: The push interval can be set to 0 for real-time push.
1. Click the Snmp tab. The default SNMP setting is “public” for Set and Get. If values are changed on the
devices, all devices must have the same value or no value (public).
The default Trap level is Printer Confirmation traps. In the default mode, only printed job traps are sent.
This is used to reduce the network traffic with unwanted traps. Some versions of HP JetDirect require
that All traps mode is selected.
2. Click Save to save the new configuration information.
6.4 DesignJet configuration
NOTE: This section applies only to DesignJet printers with built-in Job Accounting.
Some DesignJet models such as the 4000, 4500, Z610, and T1100PS have a built-in tracking function which
allows HP Access Control (HP AC) Job Accounting to parse the XML accounting file. To enable this feature, the
DesignJet must be installed and configured locally on an HP Access Control (HP AC) Job Accounting print
server, allowing HP Access Control (HP AC) Job Accounting to retrieve the IP address and the queue name.
Configure networked DesignJet printers by clicking the Modify icon in the DesignJet configuration column
on the HP Access Control (HP AC) Job Accounting print server Administration screen.
Section 6.4 DesignJet configuration 45