HP Access Control - Manual (Page 137)

1. Click the Link profile icon.
Figure 14-13 Add allocation profile parameters
2. You can use the current profile or choose another one by clicking the Modify .icon
Figure 14-14 Allocation profile
Choose ONE of the available profiles:
● Click the Go icon to accept the profile, or the Cancel icon to stop the operation.
● Enter the field values for the selected profile.
● Click the Go icon to accept again.
● The job is now linked to an allocation profile.
14.8 Modify allocation information
NOTE: After a job is linked to a profile, you cannot remove this link. However, changes can be applied to the
field values that make up the profile.
1. Search for the job requiring field value changes.
Section 14.8 Modify allocation information 123