Dwyer UXF2 - Manual (Page 92)

- 82 -
4.7.4. How to check the status output
Description
z
Check the status output.
Settable range: ON ... Short-circuits the contact. OFF ... Open-circuits the contact.
z This operation sets DO1 and DO2 with the same contact action.
z Before operation, check whether process conditions permit changing the DO output.
For concrete keying, refer to the typical operation indicated below. Set the parameter protection to OFF beforehand
(Section 4.4.1)
Typical operation Check the contact action.
Keying order Description Indication
ź
Pressed 4 times to indicate "MAINTENANCE MODE". MAINTENANCE MODE
ENT
ź
Pressed to indicate "CURRENT CALIBRATION". CURRENT
CALIBRATION
ź
Pressed 3 times to indicate "STATUS OUTPUT". STATUS OUTPUT
ON
ENT
ź
Pressed to blink the cursor.
Note: At this time, the contact output is set as indicated.
In the example shown on the right, the contact
output is set as “ON”.
STATUS OUTPUT
ON
ź
Pressed to select "OFF". STATUS OUTPUT
OFF
Pressed to register "OFF". STATUS OUTPUT
½½ COMPLETE ½½
Ļ
ENT
ź
ź
ź
ź
--- "OFF" registered.---
* Make sure the contact output is "OFF".
STATUS OUTPUT
OFF
ź
Pressed to select "ON". STATUS OUTPUT
ON
Pressed to register "ON". STATUS OUTPUT
½½ COMPLETE ½½
Ļ
ENT
ź
ź
ź
ź
--- "ON" registered.---
* Make sure the contact output is "ON".
STATUS OUTPUT
ON
ESC
ź
Pressed once to stop the blinking of the cursor.
* At this time, the contact output is set at normal
measurement status.
STATUS OUTPUT
ON
ESC Press ESC key once, and key once to resume the
measurement mode.
0.000 m/s
0.000 m3/h
BULLETIN F-70