Dwyer UXF2 - Manual (Page 72)

- 62 -
Pressed to start a total operation. TOTAL MODE
½½ COMPLETE ½½
Ļ
ENT
ź
ź
ź
ź
--- Total operation has started.--- TOTAL MODE
START
ESC Press ESC key 3 times, and key 3 times to
resume the measurement mode.
0.00 m3/h
+ 0.00 m3
4.5.6.4. Determining how to handle total at error (BURNOUT)
Description
BURNOUT(TOTAL)
z
Determines how to handle the total function when the measurement status is abnormal on account of an empty pipe
interior or bubbles mixed in fluid (common to total indication and total pulse output).
z Settable range
HOLD: Stops the total (default seting).
COUNT: Continues the total according to the flow rate prior to abnormal status indication.
BURNOUT TIMER
z
Sets the time from error occurrence (abnormal condition - LED red) to error processing.
z Settable range: 0 to 100 sec (factory set at 10 sec).
The total continues until the burnout timer is actuated.
For actual keying, refer to the typical operation indicated below. Set the parameter protection to OFF beforehand
(Section 4.4.1).
Typical operation Change the processing from "COUNT" to "HOLD", and change the burnout timer setting from 10
seconds to 15 seconds.
Keying order Description Indication
ź
Pressed twice to indicate "OUTPUT SETUP". OUTPUT SETUP
ENT
ź
Pressed to indicate "ZERO ADJUST". ZERO ADJUST
CLEAR
ź
Pressed 4 times to indicate "RANGE". RANGE
FLOW RATE
ENT
ź
Pressed to blink the cursor. RANGE
FLOW RATE
ź
Pressed to indicate "TOTAL" on 2nd line. RANGE
TOTAL
ENT
ź
Pressed to indicate "TOTAL MODE". TOTAL MODE
START
ź
Pressed 4 times to indicate "BURNOUT (TOTAL)". BURNOUT (TOTAL)
COUNT
ENT
ź
Pressed to blink the cursor. BURNOUT (TOTAL)
COUNT
BULLETIN F-70