Installation of flow transmitter, Wall mounting, 2b pipe stand mounting – Dwyer UXF2 User Manual
Page 23
3.2. Installation of flow transmitter
The flow transmitter may be mounted on a wall or 2B pipe stand (option).
3.2.1. Wall mounting
For wall mounting, use two M8 bolts.
According to the mounting hole dimensions shown below, drill holes on the wall, and tighten M8 bolts.
3.2.2. 2B pipe stand mounting
When mounting on 2B pipe, be sure to use the complete set of fixtures (U bolt, support fixture, plain washer,
spring washer, wing nut) that are provided. Tighten the wing nut by hand. Assemble pipe mounting
components as shown in the figure below and do not overtighten. Overtightening may warp or damage the
plastic enclosure.
Mount the instrument on 2B pipe stand as illustrated below.
- 13 -
3.2. Installation of flow transmitter
2B Pipe stand
U - bolt
Fixture assembly
Plain washer
Spring washer
Wing nut
- 166T (1 page)
- 160S (2 pages)
- PAFS-1000 (1 page)
- 160F (2 pages)
- Mark II WSI (4 pages)
- MW-1 (2 pages)
- 89088 (12 pages)
- 660 (2 pages)
- 670 (16 pages)
- FLST (4 pages)
- AFG (6 pages)
- FAFM (2 pages)
- DAFM (2 pages)
- STRA (4 pages)
- 530 (2 pages)
- AVFS (2 pages)
- 641RM (4 pages)
- 641B (4 pages)
- 641 (4 pages)
- VTT (2 pages)
- SFI-700 (2 pages)
- GFM (32 pages)
- GFC (40 pages)
- DMF (44 pages)
- GFM2 (20 pages)
- GFM3 (22 pages)
- TFP-LI (30 pages)
- TFP-GI (27 pages)
- TBS (7 pages)
- HFT (4 pages)
- CAM (6 pages)
- PWD (3 pages)
- BAT (3 pages)
- FPCA (4 pages)
- FPCA (2 pages)
- SPK (4 pages)
- MFS (8 pages)
- LOFM (3 pages)
- FLMG (12 pages)
- MFS2 (16 pages)
- PFT (4 pages)
- IPFS (7 pages)
- UFB (48 pages)
- UFC (56 pages)
- Series PUB (44 pages)