Dwyer UXF2 - Manual (Page 81)

- 71 -
Time
Setting
value
ON or OFF
Total value
4.5.7.6. How to validate the total switch
Description
z
Select a contact output as DO1 and/or DO2 when the total value
exceeds a set value.
Settable range: 0.000001 to 99999999
Contact action:
ACTIVE ON ..... DO1 normally OFF, DO2 normally open.
ACTIVE OFF ... DO1 normally ON, DO2 normally closed.
Note: Different values can be assigned to DO1 and DO2.
For actual keying, refer to the typical operation indicated below.
Set the parameter protection to OFF beforehand (Section 4.4.1).
Typical operation Set the DO1 output to “TOTAL SWITCH”, and change the setting from 10000 [m 3 ] to 100 [m 3 ].
Also, set the contact to Normally OFF.
Keying order Description Indication
ź
Pressed twice to select the OUTPUT SETUP mode. OUTPUT SETUP
ENT
ź
Pressed to indicate ZERO ADJUST. ZERO ADJUST
CLEAR
ź
Pressed 5 times to indicate "DO1 OUT".
* Pressing key again will select "DO2".
DO1 OUT
NOT USED
ENT
ź
Pressed to blink the cursor. DO1 OUT
NOT USED
ź
Pressed 6 times to select "TOTAL SWITCH" on 2nd line. DO1 OUT
TOTAL SWITCH
ENT
ź
Pressed to indicate the setting screen for "TOTAL
SWITCH". TOTAL SWITCH
10000 m3
ENT
ź
Pressed to blink the cursor. TOTAL SWITCH
0 0010000 m3
ź
Pressed 3 times to move the cursor. TOTAL SWITCH
000
1 0000 m3
ź
Pressed 10 times to select "0". TOTAL SWITCH
000 0 0000 m3
ź
Pressed twice to move the cursor TOTAL SWITCH
00000
0 00 m3
ź
Pressed to select "1". TOTAL SWITCH
00000 1 00 m3
Pressed to register it. TOTAL SWITCH
½½ COMPLETE ½½
Ļ
ENT
ź
ź
ź
ź
--- "TOTAL SWITCH" registered.--- STATUS OUT
CONTACT ACTION
BULLETIN F-70