Dwyer UXF2 - Manual (Page 77)

- 67 -
4.5.7.3. How to validate outputting the FLOW SPAN-2
Description
z
Select a contact output as DO1 and/or DO2 at FLOW SPAN-2 measurement status.
For actual keying, refer to the typical operation indicated below. Set the parameter protection to OFF beforehand
(Section 4.4.1).
Typical operation Set the DO1 output to "FLOW SPAN-2". Also set the contact to Normally OFF.
Keying order Description Indication
ź
Pressed twice to select the OUTPUT SETUP mode. OUTPUT SETUP
ENT
ź
Pressed to indicate ZERO ADJUST. ZERO ADJUST
CLEAR
ź
Pressed 5 times to indicate "DO1 OUT".
* Pressing key again will select "DO2".
DO1 OUT
NOT USED
ENT
ź
Pressed to blink the cursor. DO1 OUT
NOT USED
ź
Pressed 3 times to indicate "FLOW SPAN-2" on 2nd line. DO1 OUT
FLOW SPAN-2
Pressed to register "FLOW SPAN-2". DO1 OUT
½½ COMPLETE ½½
Ļ
ENT
ź
ź
ź
ź
--- "FLOW SPAN-2" registered.--- STATUS OUT
CONTACT ACTION
ENT
ź
Pressed to indicate "CONTACT ACTION". CONTACT ACTION
ACTIVE ON
Pressed to register "ACTIVE ON" (normally OFF).
* If it is desired to select Normally ON, press key.
CONTACT ACTION
½½ COMPLETE ½½
Ļ
ENT
ź
ź
ź
ź
--- "ACTIVE ON" registered.--- STATUS OUT
CONTACT ACTION
ESC Press ESC key twice, and key 3 times to resume
the measurement mode.
0.000 m/s
0.000 m3/h
BULLETIN F-70