Dwyer UXF2 - Manual (Page 88)

- 78 -
ź
Pressed to indicate "PIPE MATERIAL". Because PVC
(factory set) is already registered, go to the next step.
Note: If the pipe is made of another material, press ENT
key, and select a corresponding menu.
PIPE MATERIAL
PVC
ź
Pressed to indicate "WALL THICKNESS". WALL THICKNESS
4.50 mm
ENT
ź
Pressed to blink the cursor. WALL THICKNESS
0 04.50 mm
ź
Operated to compose "7.0" because, from piping data in
Section 6.6., the wall thickness of polyvinyl chloride pipe
(tap water size) is 7.0 mm. WALL THICKNESS
007.
0 0 mm
Pressed to register the wall thickness. WALL THICKNESS
½½ COMPLETE ½½
Ļ
ENT
ź
ź
ź
ź
--- “WALL THICKNESS” registered.--- WALL THICKNESS
7.00 mm
ź
Pressed to indicate "LINING MATERIAL".
"NO LINING" (factory set) is already registered.
Because there is no lining, go to the next step.
Note: If lining is provided, press ENT key, and select a
corresponding menu. Or, input a sound velocity.
Next, go to "LINING THICKNESS", and input a
lining thickness. Nothing is indicated in case of
"NO LINING".
LINING MATERIAL
NO LINING
ź
Pressed to indicate "KIND OF FLUID". Because
"WATER" (factory set) is already registered, go to the
next step.
Note: If fluid to be measured is other than water, press
ENT key, and input the sea water or measurement
fluid's sound velocity.
KIND OF FLUID
WATER
ź
Pressed to indicate "KINEMATIC VISCO". Input the
kinematic viscosity of the fluid to be measured. Because
the kinematic viscosity 1.0038E–6 [m
2 /s] of water at 20 qC
is already registered, go to the next step. In case of fluid
other than water, input the kinematic viscosity at a
measurement status of fluid to be measurued referring to
data in Section 6.6., etc.
KINEMATIC VISCO
1.0038 E–6m2/s
ESC
ź
Pressed to indicate "PIPE PARAMETER". "S= 31" is
indicated on 2nd line. After mounting the frames on
piping, insert into it 2 sensor units spaced at 31 divisions. PIPE PARAMETER
S= 31 ( 93mm)
ESC Press ESC key once, and key twice to resume
the measurement mode.
0.00 m3/h
+ 0.00 m3
BULLETIN F-70