Installation and procedures prior to operation, Outline of installation procedure – Dwyer UXF2 User Manual
Page 22
- 12 -
3. INSTALLATION AND PROCEDURES PRIOR
TO OPERATION
3.1. Outline of installation procedure
(1) Select the flow transmitter and detector installation places.
(2) Install and wire the flow transmitter.
(3) Turn on power.
(4) Set the piping parameters, and calculate the sensor unit spacing (if already programmed, check the sensor unit
spacing).
(5) Mount the frame on the piping to measure on.
(6) Mount the sensor unit.
(7) Set the measurement range.
(8) Adjust zero point.
(9) Start a measurement.
BULLETIN F-70
See also other documents in the category Dwyer Accessories for air:
- 166T (1 page)
- 160S (2 pages)
- PAFS-1000 (1 page)
- 160F (2 pages)
- Mark II WSI (4 pages)
- MW-1 (2 pages)
- 89088 (12 pages)
- 660 (2 pages)
- 670 (16 pages)
- FLST (4 pages)
- AFG (6 pages)
- FAFM (2 pages)
- DAFM (2 pages)
- STRA (4 pages)
- 530 (2 pages)
- AVFS (2 pages)
- 641RM (4 pages)
- 641B (4 pages)
- 641 (4 pages)
- VTT (2 pages)
- SFI-700 (2 pages)
- GFM (32 pages)
- GFC (40 pages)
- DMF (44 pages)
- GFM2 (20 pages)
- GFM3 (22 pages)
- TFP-LI (30 pages)
- TFP-GI (27 pages)
- TBS (7 pages)
- HFT (4 pages)
- CAM (6 pages)
- PWD (3 pages)
- BAT (3 pages)
- FPCA (4 pages)
- FPCA (2 pages)
- SPK (4 pages)
- MFS (8 pages)
- LOFM (3 pages)
- FLMG (12 pages)
- MFS2 (16 pages)
- PFT (4 pages)
- IPFS (7 pages)
- UFB (48 pages)
- UFC (56 pages)
- Series PUB (44 pages)