Dwyer UXF2 - Manual (Page 84)

- 74 -
4.6. Measure setup mode
4.6.1. How to set the unit system
Description
z
Select a measurement unit system.
z Metric system (factory set)
Length································ mm
Flow velocity ····················· m/s
Flow rate···························· L/s, L/min, L/h, ML/d, m
3 /s, m 3 /min, m 3 /h, Mm 3 /d, BBL/s, BBL/min, BBL/h,
MBBL/d
Total··································· mL, L, m 3 , km 3 , Mm 3 , mBBL, BBL, kBBL
z Inch system
Length································ inch
Flow velocity ····················· ft/s
Flow rate···························· gal/s, gal/min, gal/h, Mgal/d, ft
3 /s, ft 3 /min, ft 3 /h, Mft 3 /d, BBL/s, BBL/min, BBL/h,
MBBL/d
Total··································· gal, kgal, ft 3 , kft 3 , Mft 3 , mBBL, BBL, kBBL, ACRE-in, ACRE-ft
For actual keying, refer to the typical operation indicated below. Set the parameter protection to OFF beforehand
(Section 4.4.1).
Typical operation Change the unit system from inch system to metric system.
Keying order Description Indication
ź
Pressed 3 times to indicate "MEASURE SETUP". MEASURE SETUP
ENT
ź
Pressed to indicate "SYSTEM UNIT". SYSTEM UNIT
ENGLISH
ENT
ź
Pressed to blink the cursor. SYSTEM UNIT
ENGLISH
ź
Pressed to indicate "METRIC". SYSTEM UNIT
METRIC
Pressed to register it. SYSTEM UNIT
½½ COMPLETE ½½
Ļ
ENT
ź
ź
ź
ź
--- "METRIC" registered.--- SYSTEM UNIT
METRIC
ESC Press ESC key once, and key twice to resume
the measurement mode.
0.000 m/s
0.000 m3/h
BULLETIN F-70