Dwyer UXF2 - Manual (Page 75)

- 65 -
4.5.7.1. Invalidating the DO output
Description
z Cancels the DO1 OUT and/or DO2 OUT contact output function.
For actual keying, refer to the typical operation indicated below. Set the parameter protection to OFF beforehand
(Section 4.4.1).
Typical operation Change the setting of DO1 from "+TOTAL PULSE" to "NOT USED".
Keying order Description Indication
ź
Pressed twice to select the OUTPUT SETUP mode. OUTPUT SETUP
ENT
ź
Pressed to indicate ZERO ADJUST. ZERO ADJUST
CLEAR
ź
Pressed 5 times to indicate "DO1 OUT".
* Pressing key again will select "DO2".
DO1 OUT
+TOTAL PULSE
ENT
ź
Pressed to blink the cursor. DO1 OUT
+TOTAL PULSE
ź
Pressed 6 times to indicate "NOT USED" on 2nd line. DO1 OUT
NOT USED
Pressed to register "NOT USED". DO1 OUT
½½ COMPLETE ½½
Ļ
ENT
ź
ź
ź
ź
--- "NOT USED" registered.--- DO1 OUT
NOT USED
ESC Press ESC key once, and key 3 times to resume
the measurement mode.
0.000 m/s
0.000 m3/h
BULLETIN F-70