Dwyer UXF2 - Manual (Page 16)

- 6 -
1.4. Names and functions of each part
1.4.1. Flow transmitter (UXF2)
No. Name Description
1 Wiring connection port,
large For power cable, output cable
2 Wiring connection port,
small Wiring connection port for signal cable only
3 Indication and setting unit Indicates and sets the flow rate, etc.
4 Received wave diagnostic
indication Indicates whether received wave is normal (green) or abnormal (red).
5 Escape key Return to the next-higher layer or cancels the set status.
6 UP key Selects items, numeric values and symbols.
7 Shift key Moves the cursor and selects decimal place.
8 Entry key Enters a selection or registers a setting.
9 LCD indication Indicates the flow rate or setting.
10 Power terminals Power cables are connected.
11 Input/output terminals Signal cable, analog output and DO output cables are connected.
12 Communication board
terminals
Communication cable is connected (communication board is optional).
13 Fuse holder Houses a fuse.
14 Relay For DO2 output
15 Communication board Mounted if communication synchronization is optionally designated.
16 Arrester board Board for output mounted if arrester is optionally designated.
BULLETIN F-70