Dwyer UXF2 - Manual (Page 71)

- 61 -
4.5.6.3. TOTAL mode (total reset, start, stop)
Description
z
The total is started, stopped or reset.
z Settable range: START, STOP, RESET.
START: Carried out the total.
STOP: Stops the total.
RESET: Reset the total memory to the preset value.
Notes
1. A resetting action simultaneously resets both forward total memory and reverse total memory.
2. To start a total after resetting a total value, be sure to set the "START".
For actual keying, refer to the typical operation indicated below. Set the parameter protection to OFF beforehand
(Section 4.4.1).
Typical operation Reset the total value (preset value 0 m 3 ), and restart a total.
Keying order Description Indication
0.00 m3/h
+ 127.26 m3
ź
Pressed twice to indicate "OUTPUT SETUP". OUTPUT SETUP
ENT
ź
Pressed to indicate "ZERO ADJUST". ZERO ADJUST
CLEAR
ź
Pressed 4 times to indicate "RANGE". RANGE
FLOW RATE
ENT
ź
Pressed to blink the cursor. RANGE
FLOW RATE
ź
Pressed to indicate "TOTAL" on 2nd line. RANGE
TOTAL
ENT
ź
Pressed to indicate "TOTAL MODE". TOTAL MODE
START
ENT
ź
Pressed to blink the cursor. TOTAL MODE
START
ź
Pressed twice to indicate "RESET". TOTAL MODE
RESET
Pressed to execute "RESET".
Note: After resetting, the total operation automatically
stops. To resume a total, execute "START".
TOTAL MODE
½½ COMPLETE ½½
Ļ
ENT
ź
ź
ź
ź
--- RESET has ended.--- TOTAL MODE
STOP
ENT
ź
Pressed to blink the cursor. TOTAL MODE
STOP
ź
Pressed twice to indicate "START". TOTAL MODE
START
BULLETIN F-70