Dwyer UXF2 - Manual (Page 83)

- 73 -
100%
Flow rate
Output
4.5.8. How to compensate the measurement value
Description
z
Used for compensating the measurement value.
The span can be compensated by a preset reading percentage.
Compensatable range: ±200%
The output value (reading, analog output and total output) is
computed by the following expression.
Output =
measurement value u [compensation value %]
100
For actual keying, refer to the typical operation indicated below. Set the parameter protection to OFF beforehand
(Section 4.4.1).
Typical operation Compensate the measurement value by 1 %.
Keying order Description Indication
ź
Pressed twice to select the OUTPUT SETUP mode. OUTPUT SETUP
ENT
ź
Pressed to indicate ZERO ADJUST. ZERO ADJUST
CLEAR
ź
Pressed 7 times to indicate "CALIBRATION SPAN". CALIBRATION SPAN
100.0 %
ENT
ź
Pressed to blink the cursor. CALIBRATION SPAN
1 00.0 %
ź
Pressed twice to move the cursor. CALIBRATION SPAN
10
0 .0 %
ź
Pressed to select "1". CALIBRATION SPAN
10
1 .0 %
Pressed to register it. CALIBRATION SPAN
½½ COMPLETE ½½
Ļ
ENT
ź
ź
ź
ź
--- Compensation value registered.--- CALIBRATION SPAN
101.0 %
ESC Press ESC key once, and key 3 times to resume
the measurement mode.
0.000 m/s
0.000 m3/h
BULLETIN F-70