Brocade Virtual ADX Server Load Balancing Guide (Supporting ADX v03.1.00) - Manual (Page 68)

52 Brocade Virtual ADX Server Load Balancing Guide
53-1003247-01
Primary and backup servers
2
Configuration example
The example configures load-balancing shown in Figure 10 on page 50.
To configure the real servers, enter commands such as the following.
Virtual ADX(config)#server real R1 10.10.10.10
Virtual ADX(config-rs-R1)#port http
Virtual ADX(config-rs-R1)#exit
Virtual ADX(config)#server real R2 10.10.10.20
Virtual ADX(config-rs-R2)#port http
Virtual ADX(config-rs-R2)#exit
Virtual ADX(config)#server real R3 10.10.10.30
Virtual ADX(config-rs-R3)#backup
Virtual ADX(config-rs-R3)#port http
Virtual ADX(config-rs-R3)#exit
Virtual ADX(config)#server remote-name R4 10.10.10.40
Virtual ADX(config-rs-R4)#port http
Virtual ADX(config-rs-R4)#exit
Virtual ADX(config)#server remote-name R5 10.10.10.50
Virtual ADX(config-rs-R5)#backup
Virtual ADX(config-rs-R5)#port http
Notice that the backup command is used with servers R3 and R5.
To configure the VIP, enter commands such as the following.
Virtual ADX(config-rs-R5)#server virtual-name-or-ip VIP1 10.10.10.100
Virtual ADX(config-vs-VIP1)#port http lb-pri-servers
Virtual ADX(config-vs-VIP1)#bind http R1 http R2 http R3 http R4 http R5 http