Brocade Virtual ADX Server Load Balancing Guide (Supporting ADX v03.1.00) - Manual (Page 397)

Brocade Virtual ADX Server Load Balancing Guide 381
53-1003247-01
Displaying port-binding information
B
Name: MyServer03 IP:192.168.160.93 State: Enabled
Port 8083: Failed
Port http: Failed
Syntax: show server port failed
Displaying port-binding information
Using the “show server bind” command
To display port-binding information, enter the following command.
Syntax: show server bind
The display lists the port bindings for each virtual server configured on the Brocade Virtual ADX.
The first row of information for each virtual server lists the virtual server name and VIP. The
following rows list the TCP/UDP ports configured on the virtual server and the real servers and port
names or numbers to which each port is bound.
In the example, two virtual servers are configured on the Brocade Virtual ADX, v100 and v105. The
first set of rows in the example output is for virtual server v100, with VIP 10.157.23.100.
The rows below the first row list the real servers and ports to which the virtual server’s ports are
bound. The rows are grouped by port type. The first two rows after the first row in the example
above list the port bindings for the virtual server’s HTTP port. In this case, the virtual server is
bound to an HTTP port on two real servers, s43 and s60. The port name or number on the real
server is listed after the real server’s IP address. In this example, the HTTP port to which v100 is
bound on s43 is "http", which is the well-known name for the port. The virtual server’s HTTP port is
bound to port 8080 on real server s60.
Using the “show server session” command
You can also display port-binding information by entering the show server session command.
SLB-Virtual ADX#show server bind
http -------> s43: 10.157.23.43, http
s60: 10.157.23.60, 8080
ftp -------> s43: 10.157.23.43, ftp
s60: 10.157.23.60, ftp
70 -------> s43: 10.157.23.43, 70
s60: 10.157.23.60, 70
Virtual Server Name: v105, IP: 10.157.23.105
telnet -------> s60: 10.157.23.60, 300
ftp -------> s60: 10.157.23.60, 200
http -------> s60: 10.157.23.60, 100
dns -------> s60: 10.157.23.60, 400
tftp -------> s60: 10.157.23.60, 500