Brocade Virtual ADX Server Load Balancing Guide (Supporting ADX v03.1.00) - Manual (Page 387)

Brocade Virtual ADX Server Load Balancing Guide 371
53-1003247-01
Displaying real server information and statistics
B
Displaying real server information and statistics
Using the show server real command
Use the show server real command to view real IP addresses as well as configuration information
and basic statistics for all the real servers configured on the Brocade Virtual ADX.
To display configuration information for a specific real server, enter the show server real command
using its server name or IP address such as in the following example:
Syntax: show server real server-name | ip-address
The server-name variable specifies the real server by name. Alternatively, the ip-address variable
may be used to specify the real server by its IP address.
Table 41 describes the information returned by the show server real command.
TABLE 41 Real server information
Field Description
Server State Codes
State (St) The possible values for the server state. The state of each real server is
shown by the State field, described in this table.
General Server Parameters
Name The name of the real server. This is the name you assigned to the server
when you configured it on the Brocade Virtual ADX.
Virtual ADX(config)#show server real r6
Real Servers Info
========================
State(St) - ACT:active, ENB:enabled, FAL:failed, TST:test, DIS:disabled,
UNK:unknown, UNB:unbind, AWU:await-unbind, AWD:await-delete
HLD:held-down
Name: r6 State: Active Cost: 0 IP:400::457: 1
Mac: 0000.855d.e2cd Weight: 1/1 MaxConn: n/a
SrcNAT: not-cfg, not-op DstNAT: not-cfg, not-op Serv-Rsts: 0
Rx throughput: 190 Kbps Tx throughput: 340 Kbps
tcp conn rate:udp conn rate = 9:0
Use local conn : No
Port St Ms CurConn TotConn Rx-pkts Tx-pkts Rx-octet Tx-octet Reas
---- -- -- ------- ------- ------- ------- -------- -------- ----
default UNB 0 0 0 0 0 0 0 0
http ACT 0 20 970 4398 4847 563498 607932 0
Server Total 0 970 4398 4847 563498 607932 0