Brocade Virtual ADX Server Load Balancing Guide (Supporting ADX v03.1.00) - Manual (Page 372)

356 Brocade Virtual ADX Server Load Balancing Guide
53-1003247-01
Using the show session all command
B
Using the show session all command
Use the show session command (available at the BP console only) to determine if the sessions
have been created correctly.
In the above example, 10.1.1.42 is the client and 10.1.1.99 is the VIP address. The IP address
10.1.15 is the real server and 10.1.1.79 is the source NAT IP.
NOTE
In the reverse session, the port 10242 has been allocated from the pool of real server 10.1.1.15.
You can verify the information by using the show source-ip command.
.
The output shows that of a total of 27648 ports, one port has been allocated and 27467 are still
available.
Virtual ADX#rconsole 1 1
Virtual ADX1/1#show session all 0
Session Info:
Flags-
0:UDP, 1:TCP, >:fwdSess, +:userCntFlgSet, D:sessInDelQ, F:fin_setFlg, A:acked
* before age indicates that the static bit is set
Index Src-IP Dst-IP S-port D-port Age Serv Flags
===== ====== ====== ====== ====== === ==== ==========
0 10.0.0.5 10.1.1.36 5 80 *0 n/a SLB1 #
1 10.0.0.5 10.1.1.99 5 80 *0 n/a SLB1 #
2 10.1.1.15 10.1.1.79 80 10242 32 n/a OPT1 #
3 10.1.1.15 10.1.1.79 80 10242 - rest SLB1 A
4 10.1.1.42 10.1.1.99 1333 80 33 n/a OPT1> #
5 10.1.1.42 10.1.1.99 1333 80 - rest SLB1>+
6 10.1.1.15 10.0.0.1 1 1 *60 n/a SLB1 #
7 10.1.1.66 10.0.0.1 1 1 *60 n/a SLB1 #
Virtual ADX#show source-ip 10.1.1.79 10.1.1.15
Source IP information
*********************
Source IP: 10.1.1.79
Real server: rest (10.1.1.15)
flt: Yes standby: No intf ip: No
port-range: 1 for ssl: No per-real-srcip: Yes
NORM: h: 3 t: 2 m: 23b33b24 T: 27648 f: 27647