Brocade Virtual ADX Server Load Balancing Guide (Supporting ADX v03.1.00) - Manual (Page 351)

Brocade Virtual ADX Server Load Balancing Guide 335
53-1003247-01
Configuring SIP SLB
7
Configuring a SIP registrar server and enabling health check
Complete the following steps to configure a real SIP registrar server and its health check.
1. Configure a real server and IP address for a registrar server and enter the real server
configuration mode.
Virtual ADX(config)#server real registrar-1 10.1.5.1
Syntax: [no] server real name ip_address
2. Specify the SIP port.
Virtual ADX(config-rs-registrar-1)#port sip
Syntax: [no] port sip
3. Specify a registrar server and a health check method with no DSR. In this scenario, health
check messages are sent directly to a real server IP address.
Virtual ADX(config-rs-registrar-1)#port sip sip-registrar health-check-no-dsr
Syntax: port sip [sip-registrar] [health-check-method [ options | register ] ]
[health-check-no-dsr]
• sip-registrar—Identifies the server as a SIP registrar.
• health-check-method—Specifies the SIP health check method.
• options—Enables health check through OPTION messages.
• register—Enables health check through REGISTER messages (default method).
• health-check-no-dsr—Specifies for health check to be sent to a real server rather than a
virtual server.
Configuring a SIP proxy plus registrar server and enabling health check
Complete the following steps to configure a real SIP proxy plus registrar server and its health check.
1. Configure a real server name and IP address for a registrar/proxy server and enter the real
server configuration mode.
Virtual ADX(config)#server real registrar-proxy-server-5 10.1.9.5
Syntax: [no] server real name ip_address
2. Specify the SIP port.
Virtual ADX(config-rs-registrar-proxy-server-5)#port sip
Syntax: [no] port sip
NOTE
You can specify SIP port number 5060 or the keyword sip.