Brocade Virtual ADX Server Load Balancing Guide (Supporting ADX v03.1.00) - Manual (Page 389)

Brocade Virtual ADX Server Load Balancing Guide 373
53-1003247-01
Displaying real server information and statistics
B
Using the show server real detail command
Use the show server real detail command to view information not only about a specified real server,
but also information about the various ports configured on that server.
Table 42 describes the information returned by the show server real detail command. The fields
apply to all the TCP/UDP ports on the real servers.
For DNS, HTTP, and RADIUS ports, the server-specific health check information for the port is listed
under the port’s statistics. For information about the health check parameters, refer to
“Changing
HTTP keepalive method, value, and status codes” on page 178.
Virtual ADX(config)#sh serv real rs1 detail
Real Servers Info
========================
State(St) - ACT:active, ENB:enabled, FAL:failed, TST:test, DIS:disabled,
UNK:unknown, UNB:unbind, AWU:await-unbind, AWD:await-delete
HLD:held-down
Name: rs1 State: Enabled Cost: 0 IP:192.168.5.3: 1
Mac: Unknown Weight: 1/1 MaxConn: n/a
SrcNAT: not-cfg, not-op DstNAT: not-cfg, not-op Serv-Rsts: 0
Mem: Server: 2e09f26a Dynamic: No
Fail port exist: Y
Rx throughput: 804 Kbps Tx throughput: 1810 Kbps
tcp conn rate:udp conn rate = 10:20
Use local conn : No
Port St Ms CurConn TotConn Rx-pkts Tx-pkts Rx-octet Tx-octet Reas
---- -- -- ------- ------- ------- ------- -------- -------- ----
default UNB 0 0 0 0 0 0 0 0
max_conn = 2000000 fail time = 0, Vir IP 0.0.0.0
tcp conn rate:udp conn rate = 0:0, max tcp conn rate:max udp conn rate =
:0
Rx throughput: 0 Kbps Tx throughput: 0 Kbps
BP max local conn configured No: 0 0 0 0 0 0
BP max conn percentage configured No: 0 0 0 0 0 0
Use local conn : No
http ENB 0 0 500 2000 1000 300000 200000
max_conn = 2000000 fail time = 0, Vir IP 192.168.5.1
tcp conn rate:udp conn rate = 10:0, max tcp conn rate:max udp conn rate =
SIP TCP Current Connections = 0
Rx throughput: 144 Kbps Tx throughput: 566 Kbps
BP max local conn configured No: 0 0 0 0 0 0
BP max conn percentage configured No: 0 0 0 0 0 0
Use local conn : No
Keepalive(G/L:On/Off):On