Brocade Virtual ADX Server Load Balancing Guide (Supporting ADX v03.1.00) - Manual (Page 203)

Brocade Virtual ADX Server Load Balancing Guide 187
53-1003247-01
Port profiles and attributes
4
Displaying virtual server state information
To display virtual server information, enter the following command at any level of the CLI.
Information about the remaining virtual servers has been omitted for brevity.
Syntax: show server virtual
In this example, the virtual server and the application ports configured on the server are enabled,
indicating that the server and the application ports are configured on the Brocade Virtual ADX but
the Brocade Virtual ADX is not connected to the real servers bound to this virtual server. Refer to
“Displaying real server state information” on page 186 for descriptions of the server and
application states.
Port profiles and attributes
A port profile is a set of attributes that globally defines an application port. Once defined, the port
has the same attributes on all the real and virtual servers that use the port. Port profiles are useful
if you want to globally change the attributes of a port known to the Brocade Virtual ADX (refer to the
list in
“Port-specific settings for Layer 7 health checks” on page 176) or you want to globally define
a port that is not known to the Brocade Virtual ADX. You also can specify or change port attributes
locally, on the real server and virtual server configuration levels.
If you want to enable the keepalive health check for an application port, you must configure a port
profile for the port.
Virtual ADX(config)#show server virtual
Virtual Servers Info
Name: v100 State: Enabled IF DWN IP:10.157.23.100 : 4
Pred: round-robin ACL-Id: 0 TotalConn: 0
VIP state: Healthy
Rx pkts: 0 Tx pkts: 0
Rx bytes: 0 Tx bytes: 0
Rx PPS: 0 Tx PPS: 0
Rx Throughput: 0 Kbps Tx Throughput: 0 Kbps
tcp-conn-rate: 0 udp-conn-rate: 0
CPS: 0 CurrConn: 0
Note: The above statistics lag by 1 second
Port State Sticky Concur Proxy DSR CurConn TotConn PeakConn
---- ----- ------ ------ ----- --- ------- ------- --------
default enabled NO NO NO NO 0 0 0
http enabled NO NO NO NO 0 0 0
Port Rx-pkts Tx-pkts Rx-octet Tx-octet
---- ------- ------- -------- --------
default 0 0 0 0
http 0 0 0 0