Brocade Virtual ADX Server Load Balancing Guide (Supporting ADX v03.1.00) - Manual (Page 101)

Brocade Virtual ADX Server Load Balancing Guide 85
53-1003247-01
Disabling or deleting VIPs and real ports
2
Enabling the port hold down timer for an individual real server port
You can configure the port hold down timer to enable port holddown for an individual port within a
real server configuration.
Virtual ADX(config)#server real rs1
Virtual ADX(config-real-rs1)#port http holddown
Syntax: [no] port port-type holddown
The port-type variable specifies the port that you want to apply the holddown timer to.
Enabling the port holddown timer for a port profile
You can configure the port hold down timer to enable port holddown for all ports within a server
port profile.
Virtual ADX(config)#server port http
Virtual ADX(config-port-http)#holddown
Syntax: [no] holddown
Displaying port holddown
The show server real and show server real detail commands provide information about the current
state and duration of port holddown.
In the following example, the show server real command displays the state of the “http” port as
“HLD”.
Virtual ADX(config)#show server real rs1
Real Servers Info
========================
State(St) - ACT:active, ENB:enabled, FAL:failed, TST:test, DIS:disabled,
UNK:unknown, UNB:unbind, AWU:await-unbind, AWD:await-delete,
HLD:held-down
Name: rs1 State: Active Cost: 0 IP:192.168.3.1: 1
Mac: 000c.29b6.64de Weight: 1/1 MaxConn: n/a
SrcNAT: cfg, op DstNAT: not-cfg, not-op Serv-Rsts: 0
tcp conn rate:udp conn rate = 0:0, max tcp conn rate:max udp conn rate = 0:0
BP max local conn configured No: 0 0 0 0 0 0
BP max conn percentage configured No: 0 0 0 0 0 0
Use local conn : No
Port St Ms CurConn TotConn Rx-pkts Tx-pkts Rx-octet Tx-octet Reas
---- -- -- ------- ------- ------- ------- -------- -------- ----
default UNB 0 0 0 0 0 0 0 0
http HLD 0 0 0 0 0 0 0 0