Yokogawa µR20000 - Manual (Page 83)

IM 04P02B01-01E
3-14
3.8 Prntng the Recorder Settngs
This section explains the procedure for printing the recorder settings. There are two sets
of settings that can be printed: List and Setup.
List: Prints the settings of Setting mode (input range for each channel, etc.)
Setup: Prints the settings of Basic Setting mode
Note
• The printout takes several minutes to tens of minutes to complete.
• When this printout is executed, trend recording is suspended. However, the recorder
continues the measurement and alarm detection (in the background).
• When the printout is complete, trend recording resumes.
• If an alarm occurs during the printout, the alarm is printed after the trend recording resumes.
Procedure
Startng the Lst Prntout
1. Press the FUNC key.
2. Press the key to select Prnt out and then press the key.
3. Press the key to display Lst Start and then press the key.
The List printout starts. The screen returns to the data display screen.
Print=List Start
Abortng the Lst Prntout
1. Press the FUNC key.
2. Press the key to select Prnt out and then press the key.
3. Press the key to display Lst Stop and then press the key.
The List printout stops. The screen returns to the data display screen.
Print=List Stop
Startng the Setup Prntout
1. Press the FUNC key.
2. Press the key to select Prnt out and then press the key.
3. Press the key to display Setup Start and then press the key.
The Setup printout starts. The screen returns to the data display screen.
Print=Setup Start
Abortng the Setup Prntout
1. Press the FUNC key.
2. Press the key to select Prnt out and then press the key.
3. Press the key to display Setup Stop and then press the key.
The Setup printout stops. The screen returns to the data display screen.
Print=Setup Stop
* When the key or key is pressed while holding down the SHIFT key, the operation is reversed as
when the respective key is pressed by itself.