Yokogawa µR20000 - Manual (Page 50)

IM 04P02B01-01E
1-34
1.10 Functon Setup Gude
This section explains the settings necessary to use various functions of the recorder.
Read the section corresponding to the function you wish to use.
Note
This section contains all the settings related to each item. If the desired setting is the same as
the default value, you do not have to set it.
Item Descrpton Reference
Secton
Date/Time setting Use Clock in Setting mode 5.5
DST Sets the date/time for switching between DST and standard time using Aux > DST in
Setting mode.
6.16
Setting initialization Use Intalze in Basic Setting mode to initialize the settings of Setting mode and Basic
Setting mode to their default values.
7.17
Measurng nput functons
Item Descrpton Reference
Secton
Range and span of the TC, RTD, or DC voltage
Use Range in Setting mode. 5.1
1-5V • Range, span, and scale 5.1
Use Range in Setting mode.
• Unit 5.3
Use Unt in setting mode to set the unit after scaling.
• Low-cut 7.15
Use Personalze > Add functon > 1-5V low-cut in Basic Setting mode and select
Use or Not.
5.1
If Use is selected, turn On/Off Low-cut using Range in Setting mode.
If Not is selected, the Low-cut item does not appear in the Range setting.
Scaling • Range, span, and scale 5.1
Use Range in Setting mode.
• Unit 5.3
Use Unt in setting mode to set the unit after scaling.
Square Root Computation • Range, span, and scale 5.1
Use Range in Setting mode.
• Unit 5.3
Use Unt in setting mode to set the unit after scaling.
• Low-cut 7.15
Use Personalze > Add functon > SQRT low-cut in Basic Setting mode and select
Use or Not.
If Use is selected, set the Low-cut pont using Range in Setting mode. 5.1
If Not is selected, the Low-cut item does not appear in the Range setting.
Unused channels Use Range > Skp in Setting mode to disable the trend recording (dot model) and
periodic printout of the target channel.
5.1
Bias Use Personalze > Add functon > Bas in Basic Setting mode and select Use or Not. 7.15
If Use is selected, set the bias value that is added to the input using Bas in Setting
mode. If Not is selected, the Bas item does not appear.
6.12
Burnout detection function (TC input and 1-5V input) 7.3
Use Burnout in Basic Setting mode to set the burnout detection function for each
channel.
RJC of TC input Use RJC in Basic Setting mode to select whether to use the internal RJC function or
an external RJC function.
7.4
Filter (pen model) Use Flter in Basic Setting mode and select Use or Not. 7.12
If Use is selected, set the filter time constant using Aux > Flter in Setting mode. 6.2
If Not is selected, the Aux > Flter item does not appear.