2 setting the computing equation, 2 setting the computing equation -2, 2 settng the computng equaton – Yokogawa µR20000 User Manual
Page 185
IM 04P02B01-01E
9-2
9.2 Settng the Computng Equaton
The computing equation cannot be entered when the computation is in progress. If you
change the computing equation or the recording span, set the alarm and the partial
expanded recording again.
Procedure
1.
Hold down the
MENU
key for 3 seconds to enter Setting mode.
2.
Press the
key or
SHIFT +
key to select
Math and then press the key.
3
Press the key with
Formula shown on the screen.
4.
Set each item and press the key.
Use the
key or
SHIFT +
key to select values.
For the procedure on how to enter values or characters, see section 4.2.
If you press the
ESC/?
key in the middle of the operation, the settings entered up to
then are cancelled, and the display returns to a higher level menu.
5.
When the
Settng complete screen appears, do either of the following:
Press the key to set other channels.
If you are done, press the
ESC/?
key.
6.
Hold down the
MENU
key for 3 seconds to return to Operation mode.
The new setting takes effect.
ESC/?
Select On to use the computing equation.
Set the channel range.
Set the equation.
Set the left span value.
Set the right span value.
First channel
Last channel
Set=Math
Math=Formula
CH=0A-0A
Mode=Off
formula=01
Span left= -200.00
Span right= 200.00
0A-0A Channel
Setting complete
Settng the Computng Equaton
The
CHARACTER,
, and
keys are used to set the computing equation.
Use the
key or
SHIFT +
key to select the position for entering a character.
Use the
CHARACTER key or SHIFT + CHARACTER key to select the character type.
Use the
key or
SHIFT +
key to select the character.