Yokogawa µR20000 User Manual
Page 203
IM 04P02B01-01E
9-20
9.12 Settng the Tmer Used n TLOG Computaton
and Perodc Prntout
This section explains the details of setting the timer used in TLOG computation and
periodic printout.
Basic Setting mode cannot be entered when recording is in progress or when computation
is in progress on models with the computation function (/M1 option).
Procedure
Changng the Settngs
1.
Hold down the
MENU
key for 3 seconds to enter Setting mode.
2.
Hold down the
and
keys simultaneously for 3 seconds to enter Basic
Setting mode.
3.
Press the
key or
SHIFT +
key to select
Math and then press the key.
4.
Press the key with
Tmer (TLOG) shown on the screen.
5.
Set each item and press the key.
Use the
key or
SHIFT +
key to select values.
For the procedure on how to enter values or characters, see section 4.2.
If you press the
ESC key in the middle of the operation, the settings entered up to
then are cancelled, and the display returns to a higher level menu.
6.
When the
Settng complete screen appears, do either of the following:
To correct the setting, press the key.
If you are done, press the
ESC key.
Select the timer No.
The new setting takes effect.
ESC/?
Select the timer type.
(When the mode is set to Absolute)
Select the timer interval.
Set the reference time.
Select On to reset the computed values
every interval.
Select On to print the computed values
every interval.
Math Timer
Setting complete
Basic=Math
Math=Timer(TLOG)
Timer number=1
Mode=Absolute
Interval=1h
Ref.Time=00:00
Reset=Off
Print=Off