Yokogawa µR20000 - Manual (Page 210)

9-27
IM 04P02B01-01E
Operat
ons
Related
to
the
Computat
on
Funct
on
(/M1
Opt
on)
1
2
3
4
5
6
7
8
9
10
11
12
App
Index
9.16 Settng the Bar Graph Dsplay Mode
This section explains the details of setting the bar graph display mode.
Basic Setting mode cannot be entered when recording is in progress or when
computation is in progress on models with the computation function (/M1 option).
Procedure
Changng the Settngs
1. Hold down the MENU key for 3 seconds to enter Setting mode.
2. Hold down the and keys simultaneously for 3 seconds to enter Basic
Setting mode.
3. Press the key or SHIFT + key to select Math and then press the key.
4. Press the key or SHIFT + key to select Bar graph and then press the
key.
5. Set each item and press the key.
Use the key or SHIFT + key to select values.
For the procedure on how to enter values or characters, see section 4.2.
If you press the
ESC key in the middle of the operation, the settings entered up to
then are cancelled, and the display returns to a higher level menu.
6. When the Settng complete screen appears, do either of the following:
Press the key to set other channels.
If you are done, press the
ESC key.
Set the channel range.
The new setting takes effect.
ESC/?
Select the display mode of the bar
graph.
First channel
Last channel
0A-0A Channel
Setting complete
Basic=Math
Math=Bar graph
CH=0A-0A
Graph=Normal
Applyng the Changes and Returnng to Operaton Mode
Press the key or SHIFT + key to select End and then press the key. Press
the key to select Store and then press the key. The changes are applied, and
the screen returns to Operation mode. If you select Abort and press the key, the
changes are discarded, and the screen returns to Operation mode. Press the ESC key to
return to the Basc= screen.
Explanaton
Graph
Normal: Sets the base point of the bar graph to the left or right of the recording span
whichever is smaller in value.
Center: Sets the base point of the bar graph to the 50% position of the recording span.