Yokogawa µR20000 - Manual (Page 77)

IM 04P02B01-01E
3-8
When the Pen (Pen Holder) Is at a Poston That Is Not Easly Accessble
If the pen (pen holder) is at a position that is not easily accessible, carry out the
procedure below to move it near the center position.
1. Turn ON the power switch and press the FUNC key.
2. Press the ( DISP ) key several times to display the Pen exchange screen.
Func=Pen exchange
3. Press the ( CH UP ) key.
The pen (pen holder) moves near the center position, and the Pen exchange = End
appears.
Note
When the pen moves, a line is drawn on the chart paper.
4. Replace the pen.
5. Press the ( CH UP ) key.
The screen returns to the data display screen.
Replacng the Plotter Pen
1. Open the door.
If recording is in progress, press the RCD key to stop the recording.
2. Open the display and key panel section.
3. Hold the plotter pen cartridge and pull it out from the pen holder.
4. Remove the cap from the new plotter pen and insert the pen firmly into the pen
holder.
5. Return the display and key panel section to its original position.
3.3 Installng/Replacng Felt Pens or Plotter Pen (Pen Model)