Yokogawa µR20000 - Manual (Page 170)

7-33
IM 04P02B01-01E
Setup
Operat
ons
for
Chang
ng/Add
ng
Funct
ons
(Bas
c
Sett
ng
Mode)
1
2
3
4
5
6
7
8
9
10
11
12
App
Index
7.21 Selectng to Show/Hde Settng Mode Menus
Select the menu for showing/hiding the Setting mode menus. This function is available
on version 1.31 or later.
Basic Setting mode cannot be entered when recording is in progress or when
computation is in progress on models with the computation function (/M1 option).
Procedure
Changng the Settngs
1. Hold down the MENU key for 3 seconds to enter Setting mode.
2. Hold down the and keys simultaneously for 3 seconds to enter Basic
Setting mode.
3. Press the key or SHIFT + key to select Select menu and then press the
key.
4. Press the key with Set mode shown on the screen.
5. Set each item and press the key.
Use the key or SHIFT + key to select values.
For the procedure on how to enter values or characters, see section 4.2.
If you press the
ESC key in the middle of the operation, the settings entered up to
then are cancelled, and the display returns to a higher level menu.
6. When the Settng complete screen appears, do either of the following:
To correct the setting the key.
If you are done, press the
ESC key.
Basic=Select menu
Range=On Select whether to display Range in
Setting mode. Select On or Off.
Bias=On Select whether to display Bias in
Setting mode. Select On or Off.
Menu=Set mode
Alarm=On Select whether to display Alarm in
Setting mode. Select On or Off.
Unit=On Select whether to display Unit in
Setting mode. Select On or Off.
Chart speed=On Select whether to display Chart
speed in Setting mode. Select
On or Off.
Aux=On Select whether to display Aux in
Setting mode. Select On or Off.
To the next page