Yokogawa µR20000 User Manual
Page 133
IM 04P02B01-01E
6-18
Feed
The available setting range is 0 to 50 mm.
POC output
You can eject the portion that is not recorded when recording stops with the pen offset
compensating recording function.
POC speed
Select the chart speed when ejecting the portion that was not recorded.
Chart speed: Feeds at the specified chart speed.
450mm/h: Fixed to feed at 450 mm/h.
Note
The following operations are performed when using the header printout function (/BT1 option).
• When the power s nterrupted and s rentroduced, recordng always stops. End
prntout/End prntout 2 s not performed.
• When recordng stop detecton s performed (opton /F1), recordng and prntout stop.
When chart paper is inserted, the instrument operates as follows.
• When detected during Start printout and recording: Recording starts after Start printout.
• When detected during End printout: When stopped, End printout/End printout 2 is not
performed.
• Until Start printout/Start printout 2 and End printout/End printout 2 finishes, the instrument
cannot transition to the next operation.
• When recording is started, the alarm and message printout information stored in the buffer
prior to recording stop is cleared.
Setting the number of digits of the lot number and enabling start
printout 2 and end printout 2: Section 7.24
6.14 Settng Up Start Prntout and End prntout (/BT1 Opton)