8 setting the message string, 8 setting the message string -8, 8 settng the message strng – Yokogawa µR20000 User Manual
Page 123
IM 04P02B01-01E
6-8
6.8 Settng the Message Strng
This section explains the details of setting the message strings to be printed on the chart
paper. Up to five message strings can be registered.
Procedure
1.
Hold down the
MENU
key for 3 seconds to enter Setting mode.
2.
Press the
key or
SHIFT +
key to select
Aux and then press the key.
3.
Press the
key or
SHIFT +
key to select
Message and then press the
key.
4.
Set each item and press the key.
Use the
key or
SHIFT +
key to select values.
For the procedure on how to enter values or characters, see section 4.2.
If you press the
ESC key in the middle of the operation, the settings entered up to
then are cancelled, and the display returns to a higher level menu.
5.
When the
Settng complete screen appears, do either of the following:
To correct the setting, press the key.
If you are done, press the
ESC key.
6.
Hold down the
MENU
key for 3 seconds to return to Operation mode.
Select the message No.
Set message string.
The new setting takes effect.
ESC/?
Set=Aux
Aux=Message
Message number=1
CHR:A-Z
Message 1
Setting complete
Explanaton
Characters That Can Be Used for Messages
Set the message using up to 16 characters.
The available characters are as follows:
Alphabet, numbers, symbols (%, #, °, @, +, –, *, /, (, ), µ, Ω,
2
,
3
, .), and space