Yokogawa µR20000 - Manual (Page 51)

1-35
IM 04P02B01-01E
Funct
onal
Explanat
on
and
Setup
Gu
de
1.10 Functon Setup Gude
1
2
3
4
5
6
7
8
9
10
11
12
App
Index
Item Descrpton Reference
Secton
Moving average (dot model)
Use Movng_AVE in Basic Setting mode and select Use or Not. 7.11
If Use is selected, set the number of samples of moving average using Aux >
Movng_AVE in Setting mode.
6.3
If Not is selected, the Aux > Movng_AVE item does not appear.
Integration time of the A/D converter 7.2
Use A/D in Basic Setting mode to set the integration time of the A/D converter.
Temperature Unit Select the temperature unit using Temperature in Basic Setting mode. 7.25
Alarm functons
Item Descrpton Reference
Secton
Alarms for each channel Use Alarm in Setting mode. 5.2
Delay high limit alarm/delay low limit alarm
• Alarm type 7.15
Use Personalze > Add functon > Alarm delay in Basic Mode and select Use or
Not.
If Use is selected, delay high limit alarm (T) and delay low limit alarm (t) become
selectable under Alarm > Type in Setting mode.
5.2
If Not is selected, alarm delay cannot be selected.
• Alarm delay time
6.10
Use Aux > Alarm delay tme in Setting mode to set the alarm delay time.
High limit on rate-of-change alarm/low limit on rate-of-change alarm
Use Alarm in Setting mode and set the channel to rate-of-change alarm. 5.2
Use Alarm > Increase in Basic Setting mode to set the interval of the high limit on
rate-of-change alarm; use Alarm > Decrease in Basic Setting mode to set the interval
of the low limit on rate-of-change alarm.
7.1
Use the alarm ACK operation
• Relay operation and display operation 7.1
Set Alarm > Behavor in Basic Setting mode to Hold and set Alarm > Indcator to
Hold.
• Executing the alarm ACK operation 3.12
Use Func > Alarm ACK in Operation mode to execute the release of the alarm
output.
Set a hysteresis on the alarm occurrence/release value of high limit alarm and low limit alarm
Use Alarm > Hysteress in Basic Setting mode to set the hysteresis to be applied to
the high limit alarm and low limit alarm of measurement channels.
7.1
Likewise, use Alarm > Math Hysteress to set the hysteresis to be applied to the high
limit alarm and low limit alarm of computation channels (/M1 option).
Change the alarm output relay operation
If Alarm > Act in Basic Setting mode set to De_energize, alarm output relay is
energized during normal operation and de-energized when an alarm occurs.
7.1
Diagnosis output Use Alarm > Dagnoss in Basic Setting mode to set the function. 7.1
Recordng functons
Item Descrpton Reference
Secton
Chart speed Use Chart in Setting mode to set the chart speed. 5.4
Turn trend recording ON/OFF (dot model)
Use Aux > Prnt out in Setting mode to set whether to trend record on each
measurement channel.
6.6
Change the recording color of measurement channels (dot model).
Use Color in Basic Setting mode to set the recording color of measurement channels. 7.5
Record by compensating for the pen offset along the time axis (pen model)
Use Aux > POC in Setting mode to turn On/Off offset compensation. 7.6
Record by setting recording zone
Use Aux > Zone in Setting mode to set the recording zone for each channel. 6.4
Partial expanded recording Use Partal in Basic Setting mode and select Use or Not. 7.13
If Use is selected, set the display mode using Aux > Partal in Setting mode. 6.5
If Not is selected, the Aux > Partal item does not appear.