IAI America XSEL-KE - Manual (Page 372)

357
Appendix
Other Parameters
No. Parameter name
Default value
(Reference)
Input range Unit Remarks
38 PC/TP data protect
setting (Symbol,
parameter)
0H 0H ~
FFFFFFFFH
Bits 0 to 3: Protect type (Parameter) (0: Read/write,
1: Read only, 2: No read/write)
Bits 4 to 7: Protect release method (Parameter) (0:
Special operation)
Bits 8 to 11: Protect type (Symbol) (0: Read/write, 1:
Read only, 2: No read/write)
Bits 12 to 15: Protect release method (Symbol) (0:
Special operation)
* Referenced by the PC/TP (PC software version
2.0.0.42 or later and TP application version 1.09 or
later)
39 (For future
expansion)
0H 0H ~
FFFFFFFFH
40 EEPROM
information check
type
3H Reference only For adjustment by the manufacture
41 Hardware
information check
type
E0H Reference only For adjustment by the manufacture
42 Hardware test type 7H Reference only For adjustment by the manufacture
43 Special monitor type 0H 0H ~
FFFFFFFFH
Change prohibited
44 (For expansion) 0
45 Special start
condition setting
0 0H ~
FFFFFFFFH
Bits 0 to 3: Enable start from PC/TP in AUTO mode
= Used exclusively by the manufacturer
(0: Do not enable, 1: Enable) (Main
application version 0.36 or later)
Bits 4 to 7: PIO program start (Input port 000)
Single start selection (0: Normal, 1:
Single start)
* When single start is selected, the next
PIO program start (input port 000) will
not be accepted as long as a program
with the same program number as the
one started by the last PIO program start
(input port 000) is running.
(Main application version 0.52 or later)
Bits 8 to 11: Permission of auto program start when
all-operation-cancellation factor is
present
(0: Do not permit, 1: Permit)
(Main application version 0.79 or later)
Bits 12 to 15: Permission of ON edge acceptance for
PIO program start (input port 000) when
all-operation-cancellation factor is
present
(0: Do not permit, 1: Permit)
* This parameter specifies an ON-edge
acceptance condition. If the starting
FRQGLWLRQLVQRWVDWLVILHGDQ³(UURU1R
A1E: Start condition non-satisfaction
HUURU´ZLOOJHQHUDWH
(Main application version 0.79 or later)
PC: PC software
TP: Teaching pendant