IAI America XSEL-KE - Manual (Page 351)

336
Appendix
I/O Parameters
No. Parameter name
Default value
(Reference)
Input range Unit Remarks
115 SIO system reserve
(SP9)
0 0H ~
FFFFFFFFH
116~1
19
(For expansion) 0
120 Network attribute 1 1 0H ~
FFFFFFFFH
Bits 0 to 3: CC-Link remote register area
H/L byte swap selection (0: Do not
swap, 1: Swap)
* The number of used ports and
number of occupied stations in I/O
parameter Nos. 14 and 15 must
match.
(Main application version 0.55 or
later)
121 Network attribute 2 0 0H ~
FFFFFFFFH
122 Network attribute 3 0 0H ~
FFFFFFFFH
123 Network attribute 4 0 0H ~
FFFFFFFFH
Bits 0 to 3: Ethernet TCP/IP message
communication
Selection whether to permit 0.0.0.0
(IP address of connection destination
can be ignored) as IP address of
connection destination on server
(0: Do not permit
1: Permit (not recommended))
* Note: Number of clients that can
be connected simultaneously to
one server port channel = 1
124 Network attribute 5 0 0H ~
FFFFFFFFH
Ethernet TCP/IP message communication attribute
Ethernet client/server type
(0: Not in use
1: Client (Automatic assignment of own port
number)
(2: Client (Specification of own port number)
o This setting is not recommended because
of device limitations, such as an error
generation when the port is opened for
approx. 10 minutes after disablement of
close response check due to a power failure
at the connection destination, etc.)
3: Server (Specification of own port number))
* Note: Number of clients that can be
connected simultaneously to one
server port channel = 1
Bits 0 to 3: IAI protocol B/TCP (MANU mode)
* PC software can be connected only in the case of
a client.
Bits 4 to 7: IAI protocol B/TCP (AUTO mode)
* PC software can be connected only in the case of
a client.
Bits 8 to 11: Channel 31 opened to user
Bits 12 to 15: Channel 32 opened to user
Bits 16 to 19: Channel 33 opened to user
Bits 20 to 23: Channel 34 opened to user
* If the parameter settings for own port number,
client/server type, IP address of connection
destination and port number of connection
destination do not match completely between the
IAI protocol B/TCP MANU and AUTO modes, the
connection will be cut off when the MANU/AUTO
mode is switched.
PC: PC software
TP: Teaching pendant